Fresh rebuilt small block Ford D3 Nascar engine 822HP - 550ft-lbs torque, 360 cubic inch with 12:1 compression ratio, professionally rebuilt here at Eatmon Racing Engines, this engine has many new parts in it. New belts, New Autolite spark plugs, New Xceldyne titanium intake and exhaust valves, New Mahle coated pistons, New PSI valve springs, New Cometic seals, New Clevite bearings, New Total Seal rings, New Cometic gasket kit, New intake pushrods, New alternator, all other parts are good used low miles parts,  Jesel .905 roller lifters, Jesel roller rocker arms, Ford SVO R451 block, Bryant crankshaft, Pankl coated rods, DLC coated wrist pins, Ford D3 CNC ported cylinder heads with matching ported intake manifold from RYR, AutoVerdi 5 stage dry sump oil pump, Moroso stainless steel dry sump oil pan, ATI balancer, Goodridge lightweight oil lines, CV Products billet rebuilt fuel pump, Stewart EMP water pump, billet aluminum 2 piece valve covers with spring oilers, Yates camshaft belt drive system with new belt. All the best parts, let us know if you have any questions. Get it while you can it will not be here long! We ship worldwide, domestic shipping is around $500, international shipping varies depending on where you are so if you need an exact quote please send your address. Engine is shipped in a wooden container for protection. Please feel free to contact us with any questions you may have. If you need additional parts for this engine we can supply them also, carburetor, starter, flywheel, clutch, bellhousing, headers etc.